10K white resin Forshape Premium - 5 kg

Using White resin Forshape

The 10K White resin Forshape is very high quality yet economical. This 3D printing resin has been specially developed for use with DLP and LCD 385 and 405nm light sources.

It offers excellent technical and aesthetic characteristics for an economical resin.

The quality and composition of the 10K White resin Forshape enable parts to be printed with a very high level of detail, low shrinkage and limited odours.

It is 4K/10K compatible and you'll get accurate models with a high level of detail and a smooth finish.

White 10K resin Forshape: key strengths

Very high level of detail: 10K resin has properties such as a low shrinkage rate, high dimensional stability and high precision. If you use 10K 3D printers with this resin, you will obtain prints with high resolution and incredible detail.

Very high compatibility: 10K resin is highly compatible, not only with the ELEGOO Saturn 2 printer, but also with most 3D printers LCD and DLP with 4K/8K/12K resolution. It is very useful for printing miniatures, models and for home 3D printing projects.

Very fast curing: Thanks to a number of adjustments, the UV resin formula has been improved to offer greater fluidity than other standard resins, enabling the print to cure quickly and efficiently.

Low odour: The composition of this standard resin gives a light odour and limits irritating odours during printing. It is also REACH and RoHS certified, guaranteeing its quality and safety.

Our recommendations for use with 10K Resin Forshape

For printers LCD with a monochrome screen, the base layer is 20 to 30 seconds and the exposure time for each layer is 2 to 3 seconds.

Simply adjust the exposure times according to the height of the layer required, and leave the rest as is.

Cleaning the white resin

Place the printed part in the wash tank of your post-processing station and fill your tank with99.9% Isopropanol (minimum 95% alcohol). Start cleaning the part for a few minutes. Rinse the part with water before drying it. Make sure it is 100% dry, as residual alcohol can cause white spots or cracks over time.

Post-curing

The curing time of the printed model is proportional to the size of the part and inversely proportional to the optical power of the curing device to the optical power of the curing chamber. The average exposure time is between 15 and 30 minutes. Don't forget to use fresh air to dry them after post-curing.

You can place your pieces in water during post-curing to limit the effect of deformation, particularly for figurines and jewellery.

Precautions for use

Shake well before use. Wear a mask and gloves when handling. This product cannot be taken orally.

Keep away from children.

Do not get product in eyes. In the event of accidental contact, rinse with plenty of water as soon as possible. Otherwise, seek medical advice immediately.

We recommend storing the resin at a temperature between 15°C and 35°C. The lower the storage temperature, the higher the viscosity of the resin. The bottle must be sealed and airtight against dust and humidity, both of which can affect print quality. Keep the resin out of direct sunlight as much as possible, as the sun contains a lot of ultraviolet light which can harden the photosensitive resin.